.\" manual page [] for pppd 2.4
-.\" $Id: pppd.8,v 1.76 2004/01/15 05:09:00 paulus Exp $
+.\" $Id: pppd.8,v 1.78 2004/11/04 09:57:42 paulus Exp $
.\" SH section heading
.\" SS subsection heading
.\" LP paragraph
Set the CHAP restart interval (retransmission timeout for challenges)
to \fIn\fR seconds (default 3).
.TP
+.B child-timeout \fIn
+When exiting, wait for up to \fIn\fR seconds for any child processes
+(such as the command specified with the \fBpty\fR command) to exit
+before exiting. At the end of the timeout, pppd will send a SIGTERM
+signal to any remaining child processes and exit. A value of 0 means
+no timeout, that is, pppd will wait until all child processes have
+exited.
+.TP
.B connect-delay \fIn
-Wait for up \fIn\fR milliseconds after the connect script finishes for
+Wait for up to \fIn\fR milliseconds after the connect script finishes for
a valid PPP packet from the peer. At the end of this time, or when a
valid PPP packet is received from the peer, pppd will commence
negotiation by sending its first LCP packet. The default value is
Require the use of MPPE, with 128\-bit encryption.
.TP
.B require-mschap
-Require the peer to authenticate itself using MS-CHAP [Microsft Challenge
+Require the peer to authenticate itself using MS-CHAP [Microsoft Challenge
Handshake Authentication Protocol] authentication.
.TP
.B require-mschap-v2
-Require the peer to authenticate itself using MS-CHAPv2 [Microsft Challenge
+Require the peer to authenticate itself using MS-CHAPv2 [Microsoft Challenge
Handshake Authentication Protocol, Version 2] authentication.
.TP
.B require-eap