Fix authentication on second time around with multilink and persist

[ppp.git] / README

diff --git a/README b/README
index d362b24e443429e01a258305357c0f4b6055d8af..f0125cdbb6cf52e66f3992f357b542a003534fe6 100644 (file)
--- a/README
+++ b/README
@@ -8,11 +8,10 @@ Introduction.
 
 The Point-to-Point Protocol (PPP) provides a standard way to establish
 a network connection over a serial link.  At present, this package
 
 The Point-to-Point Protocol (PPP) provides a standard way to establish
 a network connection over a serial link.  At present, this package

-supports IP and the protocols layered above IP, such as TCP and UDP.
-The Linux and Solaris ports of this package have optional support for
-IPV6; the Linux port of this package also has support for IPX.
+supports IP and IPV6 and the protocols layered above them, such as TCP
+and UDP.  The Linux port of this package also has support for IPX.

 
 

-This software consists of two parts:
+This PPP implementation consists of two parts:

 
 - Kernel code, which establishes a network interface and passes
 packets between the serial port, the kernel networking code and the
 
 - Kernel code, which establishes a network interface and passes
 packets between the serial port, the kernel networking code and the


@@ -29,6 +28,13 @@ code for NeXTStep, FreeBSD, SunOS 4.x, SVR4, Tru64 (Digital Unix), AIX
 and Ultrix but no active maintainers for these platforms.  Code for
 all of these except AIX is included in the ppp-2.3.11 release.
 
 and Ultrix but no active maintainers for these platforms.  Code for
 all of these except AIX is included in the ppp-2.3.11 release.
 

+The kernel code for Linux is no longer distributed with this package,
+since the relevant kernel code is in the official Linux kernel source
+(and has been for many years) and is included in all reasonably modern
+Linux distributions.  The Linux kernel code supports using PPP over
+things other than serial ports, such as PPP over Ethernet and PPP over
+ATM.
+

 
 Installation.
 *************
 
 Installation.
 *************


@@ -55,9 +61,25 @@ use any IP address.  (This only applies where the peer is
 authenticating itself to you, of course.)
 
 
 authenticating itself to you, of course.)
 
 

-What's new in ppp-2.4.4.
+What's new in ppp-2.4.5.

 ************************
 
 ************************
 

+* Under Linux, pppd can now operate in a mode where it doesn't request
+  the peer's IP address, as some peers refuse to supply an IP address.
+  Since Linux supports device routes as well as gateway routes, it's
+  possible to have no remote IP address assigned to the ppp interface
+  and still route traffic over it.
+
+* The PPP over L2TP plugin is included, which works with the pppol2tp
+  PPP channel code in the Linux kernel.  This allows pppd to be used
+  to set up tunnels using the Layer 2 Tunneling Protocol.
+
+* Several bugs have been fixed.
+
+
+What was new in ppp-2.4.4.
+**************************
+

 * Pppd will now run /etc/ppp/ip-pre-up, if it exists, after creating
   the ppp interface and configuring its IP addresses but before
   bringing it up.  This can be used, for example, for adding firewall
 * Pppd will now run /etc/ppp/ip-pre-up, if it exists, after creating
   the ppp interface and configuring its IP addresses but before
   bringing it up.  This can be used, for example, for adding firewall


@@ -66,6 +88,10 @@ What's new in ppp-2.4.4.
 * Lots of bugs fixed, particularly in the area of demand-dialled and
   persistent connections.
 
 * Lots of bugs fixed, particularly in the area of demand-dialled and
   persistent connections.
 

+* The rp-pppoe plugin now accepts any interface name (that isn't an
+  existing pppd option name) without putting "nic-" on the front of
+  it, not just eth*, nas*, tap* and br*.
+

 
 What was new in ppp-2.4.3.
 **************************
 
 What was new in ppp-2.4.3.
 **************************


@@ -222,23 +248,6 @@ BSD-Compress and Deflate (which uses the same algorithm as gzip) don't
 ever expand packets.
 
 
 ever expand packets.
 
 

-Patents.
-********
-
-The BSD-Compress algorithm used for packet compression is the same as
-that used in the Unix "compress" command.  It was apparently covered
-by U.S. patents 4,814,746 (owned by IBM) and 4,558,302 (owned by
-Unisys), and corresponding patents in various other countries (but not
-Australia).  Apparently the Unisys patent expired in the US on 20 June
-2003, but the IBM patent is still pending.
-
-If these patents are of concern in your situation, you can build the
-package without including BSD-Compress.  To do this, edit
-net/ppp-comp.h to change the definition of DO_BSD_COMPRESS to 0.  The
-bsd-comp.c files are then no longer needed, so the references to
-bsd-comp.o may optionally be removed from the Makefiles.
-
-

 Contacts.
 *********
 
 Contacts.
 *********
 


@@ -272,4 +281,3 @@ The primary site for releases of this software is:
        ftp://ftp.samba.org/pub/ppp/
 
 
        ftp://ftp.samba.org/pub/ppp/
 
 

-($Id: README,v 1.36 2005/08/26 12:56:53 paulus Exp $)