pppd: Add documentation of stop-bits option to pppd man page (#154)

[ppp.git] / pppd / pppd.8

diff --git a/pppd/pppd.8 b/pppd/pppd.8
index eed3b5b384896661db07d364abb73f8ccb52b446..2517446a7acc78d6f7d9f9c079643b219d57d674 100644 (file)
--- a/pppd/pppd.8
+++ b/pppd/pppd.8
@@ -570,6 +570,11 @@ to 1) if the \fIproxyarp\fR option is used, and will enable the
 dynamic IP address option (i.e. set /proc/sys/net/ipv4/ip_dynaddr to
 1) in demand mode if the local address changes.
 .TP
+.B lcp\-echo\-adaptive
+If this option is used with the \fIlcp\-echo\-failure\fR option then
+pppd will send LCP echo\-request frames only if no traffic was received
+from the peer since the last echo\-request was sent.
+.TP
 .B lcp\-echo\-failure \fIn
 If this option is given, pppd will presume the peer to be dead
 if \fIn\fR LCP echo\-requests are sent without receiving a valid LCP
@@ -1082,6 +1087,10 @@ When operating as an EAP SRP\-SHA1 client, attempt to use the pseudonym
 stored in ~/.ppp_pseudonym first as the identity, and save in this
 file any pseudonym offered by the peer during authentication.
 .TP
+.B stop\-bits \fIn
+Set the number of stop bits for the serial port. Valid values are 1 or 2.
+The default value is 1.
+.TP
 .B sync
 Use synchronous HDLC serial encoding instead of asynchronous.
 The device used by pppd with this option must have sync support.