interface identifier, even if the local IPv6 interface identifier
was specified in an option.
.TP
+.B ipv6cp\-accept\-remote
+With this option, pppd will accept the peer's idea of its (remote)
+IPv6 interface identifier, even if the remote IPv6 interface
+identifier was specified in an option.
+.TP
.B ipv6cp\-max\-configure \fIn
Set the maximum number of IPv6CP configure-request transmissions to
\fIn\fR (default 10).
dynamic IP address option (i.e. set /proc/sys/net/ipv4/ip_dynaddr to
1) in demand mode if the local address changes.
.TP
+.B lcp\-echo\-adaptive
+If this option is used with the \fIlcp\-echo\-failure\fR option then
+pppd will send LCP echo\-request frames only if no traffic was received
+from the peer since the last echo\-request was sent.
+.TP
.B lcp\-echo\-failure \fIn
If this option is given, pppd will presume the peer to be dead
if \fIn\fR LCP echo\-requests are sent without receiving a valid LCP
stored in ~/.ppp_pseudonym first as the identity, and save in this
file any pseudonym offered by the peer during authentication.
.TP
+.B stop\-bits \fIn
+Set the number of stop bits for the serial port. Valid values are 1 or 2.
+The default value is 1.
+.TP
.B sync
Use synchronous HDLC serial encoding instead of asynchronous.
The device used by pppd with this option must have sync support.