pppd: Add documentation of stop-bits option to pppd man page (#154)

[ppp.git] / pppd / pppd.8

diff --git a/pppd/pppd.8 b/pppd/pppd.8
index eed3b5b384896661db07d364abb73f8ccb52b446..2517446a7acc78d6f7d9f9c079643b219d57d674 100644 (file)
--- a/pppd/pppd.8
+++ b/pppd/pppd.8
@@ -570,6 +570,11 @@ to 1) if the \fIproxyarp\fR option is used, and will enable the
 dynamic IP address option (i.e. set /proc/sys/net/ipv4/ip_dynaddr to
 1) in demand mode if the local address changes.
 .TP
 dynamic IP address option (i.e. set /proc/sys/net/ipv4/ip_dynaddr to
 1) in demand mode if the local address changes.
 .TP

+.B lcp\-echo\-adaptive
+If this option is used with the \fIlcp\-echo\-failure\fR option then
+pppd will send LCP echo\-request frames only if no traffic was received
+from the peer since the last echo\-request was sent.
+.TP

 .B lcp\-echo\-failure \fIn
 If this option is given, pppd will presume the peer to be dead
 if \fIn\fR LCP echo\-requests are sent without receiving a valid LCP
 .B lcp\-echo\-failure \fIn
 If this option is given, pppd will presume the peer to be dead
 if \fIn\fR LCP echo\-requests are sent without receiving a valid LCP


@@ -1082,6 +1087,10 @@ When operating as an EAP SRP\-SHA1 client, attempt to use the pseudonym
 stored in ~/.ppp_pseudonym first as the identity, and save in this
 file any pseudonym offered by the peer during authentication.
 .TP
 stored in ~/.ppp_pseudonym first as the identity, and save in this
 file any pseudonym offered by the peer during authentication.
 .TP

+.B stop\-bits \fIn
+Set the number of stop bits for the serial port. Valid values are 1 or 2.
+The default value is 1.
+.TP

 .B sync
 Use synchronous HDLC serial encoding instead of asynchronous.
 The device used by pppd with this option must have sync support.
 .B sync
 Use synchronous HDLC serial encoding instead of asynchronous.
 The device used by pppd with this option must have sync support.