-3. Verify the Makefile in the kernel.
-
-The drivers/net/Makefile in the kernel must have the proper definition
-for the BSD compression module. As of 2.2.0a, the code will only build
-as a module. This means that if you have had an earlier version of the
-PPP logic and this is an update to the kernel then it is possible that
-the patch to the Makefile did not work and you will be left with a
-kernel which will not build correctly.
-
-Please, read carefully the following.
-
-Look that the kernel version which you are building. If the version is
-1.2.x (1.2.0 though 1.2.99999, whatever) then use the set of entries
-for the 1.2 kernel. If the kernel is for 1.3.x and resembles the lines
-in the 1.3 kernel entry then use those. There is a point in the early
-1.3 kernels where the Makefile actually was that of the 1.2 series.
-Please don't just use the 1.3 kernel change unless your makefile
-RESEMBLES the patch indicated.
-
-I don't know how to stress this enough. If you choose the wrong one
-then the makefile will not work. Your kernel build will fail. In that
-case, use the other one. There are only two variations. Please choose
-the proper one. Only one will work.
-
-Check the makefile. If your kernel is 1.2 then it should be similar to
-the following:
-
-ifdef CONFIG_PPP
-NETDRV_OBJS := $(NETDRV_OBJS) ppp.o
-CONFIG_SLHC = CONFIG_SLHC
-else
-MODULES := $(MODULES) ppp.o
-endif
-
-MODULES := $(MODULES) bsd_comp.o
-
-ifdef CONFIG_SLIP
-NETDRV_OBJS := $(NETDRV_OBJS) slip.o
-CONFIG_SLHC = CONFIG_SLHC
-else
-MODULES := $(MODULES) slip.o
-endif
-
-The critical entry is the line which says "MODULES := $(MODULES) bsd_comp.o"
-and that you don't have "NETDRV_OBJS := $(NETDRV_OBJS) ppp.o bsd_comp.o".
-
-IF YOU HAVE THE 1.3 KERNEL, the following is the expected pattern in the
-Makefile.
-
-ifeq ($(CONFIG_PPP),y)
-L_OBJS += ppp.o
-CONFIG_SLHC_BUILTIN = y
-else
- CONFIG_SLHC_MODULE = y
- M_OBJS += ppp.o
- endif
-endif
-
-ifneq ($(CONFIG_PPP),n)
- M_OBJS += bsd_comp.o
-endif
-
-ifeq ($(CONFIG_SLIP),y)
-L_OBJS += slip.o
-CONFIG_SLHC_BUILTIN = y
-else
- ifeq ($(CONFIG_SLIP),m)