X-Git-Url: http://git.ozlabs.org/?a=blobdiff_plain;f=pppd%2Fpppd.8;h=1f2b8598954ccd8ea45cf615be8829f48b48b59f;hb=db3aa5f130886194d00a0c24db1e75261f9f9798;hp=b31594ac3be8b97b5b67cacd02ae55328a37ccbf;hpb=032020241d270c53dff479a7b0eb7fe487c56a78;p=ppp.git

diff --git a/pppd/pppd.8 b/pppd/pppd.8
index b31594a..1f2b859 100644
--- a/pppd/pppd.8
+++ b/pppd/pppd.8
@@ -212,11 +212,14 @@ Set the local and/or remote 64-bit interface identifier. Either one may be
 omitted. The identifier must be specified in standard ASCII notation of
 IPv6 addresses (e.g. ::dead:beef). If the
 \fIipv6cp\-use\-ipaddr\fR
-option is given, the local identifier is the local IPv4 address (see above).
+option is given, the local identifier is the local IPv4 address and the
+remote identifier is the remote IPv4 address (see above).
+If the \fIipv6cp-use-remotenumber\fR option is given, the remote identifier
+is set to the value from \fIremotenumber\fR option.
 On systems which supports a unique persistent id, such as EUI\-48 derived
 from the Ethernet MAC address, \fIipv6cp\-use\-persistent\fR option can be
-used to replace the \fIipv6 <local>,<remote>\fR option. Otherwise the 
-identifier is randomized.
+used to set local identifier.  Otherwise both local and remote identifiers
+are randomized.
 .TP
 .B active\-filter \fIfilter\-expression
 Specifies a packet filter to be applied to data packets to determine
@@ -536,6 +539,23 @@ With this option, pppd will accept the peer's idea of its (remote)
 IPv6 interface identifier, even if the remote IPv6 interface
 identifier was specified in an option.
 .TP
+.B ipv6cp\-noremote
+Allow pppd to operate without having an IPv6 link local address for the peer.
+This option is only available under Linux.  Normally, pppd will request the
+peer's IPv6 interface identifier (used for composing IPv6 link local address),
+and if the peer does not supply it, pppd will generate one for the peer.
+With this option, if the peer does not supply its IPv6 interface identifier,
+pppd will not ask the peer for it, and will not set the destination IPv6
+link local address of the ppp interface.  In this situation, the ppp interface
+can be used for routing by creating device routes, but the peer itself cannot
+be addressed directly for IPv6 traffic until the peer starts announcing ICMPv6
+Router Advertisement or ICMPv6 Neighbor Advertisement packets.  Note that IPv6
+router must announce ICMPv6 Router Advertisement packets.
+.TP
+.B ipv6cp\-nosendip
+Don't send our local IPv6 interface identifier to peer during IPv6 interface
+identifier negotiation.
+.TP
 .B ipv6cp\-max\-configure \fIn
 Set the maximum number of IPv6CP configure-request transmissions to
 \fIn\fR (default 10).